Aluminum Parts

Aluminum Parts

I wanted a nice chrome light for my tail light and I originally thought I would chrome the one I had. After asking a few questions on the BBS I realized that I might be able to resurrect the rare VBA tail light I had with a little help.

Older tail lights on Vespas are made from cast aluminum (sometimes called "pot metal") and on my bike it was actually painted too. Aluminum does get a pitted surface over time and oxidizes if not properly maintained but it can also be polished to a mirror like finish.

The biggest problem with this tail light was the two holes that someone had drilled in the top face. I needed to fill them with aluminum so that once it was ground flush and polished the repair would not be visible. I took the light to Weiss Welding in San Francisco and for only $25 they filled the holes and left them a little proud of the aluminum face (see below).

I started removing the extra weld with a flat hand file and when I got it close to the original aluminum I switched to 200 grit sandpaper on a block. The block is important because if a block is not used your fingers will follow the high and low spots instead of just hitting the high spots. After it looked pretty good I went down to 400 grit and then sanded the entire light with 600, 1000 and finally 1500 (see below).

I bought two polishing wheels and compound for a borrowed grinder at the Eastwood Company. The first wheel and compound is used to buff the metal while the second is used to polish it to a final shine. The compound is solid and heats up when added to the rotating wheel. It is important to hold the part very securely as it can go flying in a split second. Also wear eye protection as compound can come off the wheel in your face.

Buffing and polishing definitely takes a little getting used to. The kit comes with very good instructions and it doesn't take long to get good results

The final result below looks almost as good as new!

Tidak ada komentar: